Calibration - convert reference length value with changing unit
For example, I use calibration tool to mark a known length on drawing, Calibration Page pops up with the marked length showing 1.9685 INCHES (in the left input box). I then want to change this from INCHES to MM, but doing this doesn't convert the reference figure to equivalent MM (i.e. 50mm).
I know it doesn't really matter, as it's the output dimension units that are relevant, but if I know my scale is 1:100, it makes it easier to know the output dimension I'm typing in is of the right order, i.e.:
For 1:100 scale, 50mm = 5000mm is more intuitive than 1.9685" = 5000mm.
I know I can change page setting to Metric which in my case helps (i never use imperial) but I just felt like the input conversion is missing on principle!